Water-fuelled car

Article is in translation and unfinished

According to supporters of free energy, a water-fuelled car is a hypothetical car using just water for fuel. There are no serious reports known of concept of a successful water-fuelled car. A water-fuelled car must not be confused with hydrogen vehicles which carry tanks of hydrogen to burn with oxygen as fuel.

Alleged functional principle

All water-fuelled car models discussed so far "work" on the same principle: By electrolysis, water is split into hydrogen and oxygen under energy consumption and a normal internal combustion engine is then run on oxyhydrogen. The necessary electrical energy to create the oxyhydrogen with a small electrolysis cell is taken from the alternator and/or a car battery. Such a construction can work for a limited span of time – i.e. until the car battery has been emptied and all oxyhydrogen is used up.

Since the electrical energy taken from the alternator would have to surpass the engine output, the missing energy to keep the engine running for a long time has to be supplied by ways based on esoteric hypotheses lacking scientific recognition. Further concepts discussed by supporters of such concepts are Space Energy and neutrinos (Neutrinolysis).

Refitting kits for regular engines

Refitting kit

Elektrolysis of the company FISS

Shady profiteers sell refitting kits (e.g. at eBay) which are allegedly enables the conversion of a car with a regular combustion engine into a water-fuelled car. A chemical agent necessary to allow electrolysis, e.g. baking powder, is added.

The company Fiss-Management from Erfurt, Germany (enjoying a rather damaged reputation because of a warning by the Federal Agency for Financial Market Supervision and by "Test" magazine and probably not more than a one-man-show) offers an on-board-electrolysis cell for passenger cars (2,260 €) and trucks (9,520 €). See also: Spritsparkarte

Power efficiency of on-board electrolysis

The efficiency of an alternator is usually clearly lower than the efficiency of optimized generators; additionally, alternators have to provide electrical output at various and often unfavourable rotational speeds. The efficiency ranges between 50 to 62 percent. Optimal electrolysis at room temperature (platinum electrodes and optimal potential but not more than 14V) has a maximal efficiency of ≈60%. Appliance of special high temperature electrolysis at about 800 degrees allows to achieve an efficiency of up to 98%. For simple electrolysis cells, sold as extensions, this rate is about a mere 30%. The efficiency of creating hydrogen with gasoline as a fuel is therefore approximately 8%-20%. Using oxyhydrogen as fuel (Brown's Gas) for the engine does not provide 100% either, but is similar to the efficiency of using gasoline. Otto engines only achieve an efficiency of about 30-40%. Moreover, further problems arise due to a higher combustion temperature of hydrogen and result in a higher emission of nitric oxides..

The higher temperature also causes a higher abrasion of the engine and a higher load for the cooling system; the increased need for repairs and spare parts has a negative impact on the environmental record of the system.

Conclusion: To try and operate an internal combustion engine with extra oxyhydrogen which is created on-board through electrolysis leads to a higher consumption of fuel. The more oxyhydrogen is created, the more expensive the system will be. Running a car just with oxyhydrogen created by above device leads to 4-5 times more fuel consumption:

• Kinetic energy created by gasoline combustion has an efficiency < 40 %
• The rotating alternator has an efficiency of less than 62%
• Creating hydrogen through electrolysis has an efficiency of about 60% (special optimized electrolysis cell)
• Burning hydrogen with oxygen results in an efficiency of < 40 %

Only about 0,4 x 0,62 x 0,6 x 0,4 = 6% (perhaps 10% at max.) of the gasoline's energy is used. Combustion of just gasoline results in an efficiency of 40% at max. Operating a car only with oxyhydrogen from the on-board electrolysis consumes at least 4 to 5 times as much. Massive usage of this principle (even mixed) would have catastrophic impacts from an ecological point of view due to higher CO₂ emissions and result in much higher costs.

Achieving a pure hydrogen operation with the kits offered is illusory since a usual alternator is in no way constructed to provide enough output even for a small car: The maximum output of an alternator (for large executive cars) is about 3,000 W which corresponds roughly to the drive train of a small scooter.

Producing hydrogen gas externally in industrial electrolysis facilities to supply all cars would please only the industries producing nuclear energy and brown coal since the additional huge amounts of electrical energy necessary cannot be provided by renewable energy sources. Additionally, further problems storing hydrogen and high losses would have to be addressed: Unlike gasoline, hydrogen will diffuse through the walls of usual storage tanks, so after some time, the tank will be empty...

Research done in USA proved that such an onboard water electrolysis does not make sense since fuel consumption increases, it does not decrease as claimed.

Clean World Energies and their H-Reactor

A company named Clean World Energies GmbH from the town of Jülich (Germany) advertises their so-called "H-Reactors" and "Super-Cubes" on the German market. The divices are said to decrease fuel consumption and pollution by engines by adding hydrogen. The electrical energy to power their "Electrolyser" is generated by the on-board car battery.

Ronn Motor Company

Ronn Motor Company from Texas sells the Scorpion, a sports car with an alleged consumption of 6 l/100 km (40 miles per gallon) for 150,000 US-Dollars. Manufacturers claim this was due to using the energy of the alternator to produce hydrogen which is then added to the air/fuel mixture and causes the alleged high mileage. The method is called H2GO.

The hydrogen used, created with low efficiency through electrolysis from a small water tank of eleven liters, has to be produced while driving, increasing the consumption.
Ronn Motor Company announced it will offer an H2GO Hydrogen-On-Demand (HOD) system for other vehicles allowing to convert existing vehicles for 999 USD to decrease consumption and emissions. Ronn claims consumption was reduced by 20% to 25% and CO₂-emission was reduced by 90%.

A toy car powered by a small fuel cell is marketed with the brand name of H2GO, too.

Genepax

Genepax-Auto

In June 2008 Japanese company Genepax Water Energy System presented an electric water-fuel car (Reva) claiming that it could be operated by water and air alone and would need only one liter water from any water source for an one hour drive with 80 km/h . The exact nature of the energy source was not revealed by Genepax and the manufacturer refers for its Water Energy System (WES) just to an unspecified "energy generator", which is claimed to be able to split hydrogen from water using some kind of metal hydride and a "chemical reaction". Hydrogen gas is then used as fuel.

The product of the reaction is again water. This principle would make it a perpetual motion device. With alkali metals(sodium) hydrogen may be won from water: Alas, this would not only set the hydrogen free; the oxygen would be bound to the metal and could not be used. During operation, the metal hydrid would be used up and serves as the actual energy source. It has to be created by using energy. So, the car is not powered by some wonderous energy from water, it is powered by a primary battery. Professional journals like Popular Mechanics called the alleged wondercar "Rubbish" and professional circles ignored it. The website genepax.co.jp was abandoned in february 2009. Matthes Haug still advertises Genepax as a car which drives with water.

Water-powered car of Daniel Dingel

Auto-Bild-Article about Dingel

A tinkerer and con man named Daniel Dingel from Manila [2] received worldwide attention when he brought up a "water-powered" car. Dingel claimed that his Toyota Corolla was powered by the energy of imploding compressed ether-energy. As a result even reporters of the journal Auto-Bild (a German car journal) travelled to the Philippines to report on the scam.

In December 2008 it became known that the by now 82 years old Daniel Dingel was sentenced to a maximum of 20 years imprisonment by the Parañaque City Regional Trial Court for swindle (estafa). He also had to pay actual damages of 380.000 Dollar. Dingel, who claimed that he was not interested in money, had taken 410.000 Dollar from a Dr. John Ding Young from a Taiwanese Formosa Plastics Group in 2000 to do research about his fraudulent method. But Dingel was not able to present a "hydrogen generator" and three working cars. After receiving the money Dingel did not respond to emails but presented allegedly higher offers from competing companies. He claimed that he did not want to work with Formosa Plastics Group anymore since he feared for his life. He referred to an inventor Stan Meyer who was allegedly poisoned by the oil industry in 1998. When the charges against him became known he took 375.603 Dollar out of his account, where the deposits were put. The Philippine Department of Science and Technology calls his invention a hoax.

Weblinks

• http://en.wikipedia.org/wiki/Water-fuelled_car
• Water-fueled car and Konstantin Meyl
• http://www.autobloggreen.com/2008/08/04/why-on-board-hydrogen-generators-wont-boost-your-mileage/